Problem with My Radio (1 Viewer)
- Thread starter em_i
- Start date
Austria
- Moderator
- #2
And?
Are the tuners busy?
Fill out the support template and post the required logs, if you want help
Are the tuners busy?
Fill out the support template and post the required logs, if you want help
Users who are viewing this thread
Similar threads
Thank you for pointing out that my analysis may be less than accurate. :eek: :p
Although the change to TV channel 71 may not also have been applied to the independent radio channels (different MUXes), the logs that I prepared for one of the development team does show a difference between channel 704 ("BBC Radio 4") and channel 731...
Thank you for pointing out that my analysis may be less than accurate. :eek: :p
Although the change to TV channel 71 may not also...
I have just discovered that I can no longer receive any of the independent radio channels broadcast on DVB-T in the UK. In...
I installed the new EXE on my MP 1.36 64-bit system (Win 10 laptop), and... it works fine. (y) :)
Thank you for making this change :). I hope that it will be included in the next release.
-- from CyberSimian in the UK
I installed the new EXE on my MP 1.36 64-bit system (Win 10 laptop), and... it works fine. (y) :)
Thank you for making this...
In "MP Config" the following setting enables the display of channel numbers in the TV EPG:
But there is no equivalent setting in...
MP1
MP2
MP2 - V2.3
Difference between using specific audio renderer versus "Default WaveOut Device"?
DE
Sorry, it's my fault -- I did not notice that you are using MP2. :(
MP1 has a separate configuration utility, similar to "TV Server Config". I have tried MP2 only a couple of times, and have never used it seriously. I don't know what MP2 supports with regard to adjusting audio delay, but I do know that all of the adjustments of...
Sorry, it's my fault -- I did not notice that you are using MP2. :(
MP1 has a separate configuration utility, similar to "TV...
Hi. I recently upgraded my home cinema AVR which also meant changed from sending audio from my HTPC as 5.1 using optical to 7.1...
two simultaneous recordings succeeded. All good!
two simultaneous recordings succeeded. All good!
Since upgrading from 1.36 to 1.38, MP1 no longer connects to my tuners. They no longer appear under the server in the left-hand...
Can anyone tell me the step-by-step procedure for bringing up a second channel in pip mode? I can only do it sometimes, after many tries, and it’s not clear what I am doing that makes it work on those occasions when it does. Cannot find guidance on the site.
Thanks, N.
Again, if anyone knows how to do this, would be much...
Can anyone tell me the step-by-step procedure for bringing up a second channel in pip mode? I can only do it sometimes, after many...
Can anyone tell me the step-by-step procedure for bringing up a second channel in pip mode? I can only do it sometimes, after many...