RC2 uses alot of CPU (1 Viewer)
- Thread starter stektslav
- Start date
Sweden
stektslav - What plugins do you have enabled? It could be that one of the plugins are actually causing the high CPU, recommend disabling all of them and see happens then. Also just go back to the BlueTwo skin, I also would turn off animations to just get down to a base level.
Users who are viewing this thread
Similar threads
Result, it works on the two PC's we use for watching TV :D I've not lost anything by the looks of it either, all channels etc still setup.
Just my office PC won't connect, which I only use for testing things anyway (I tried updating that this morning as well), but I'll uninstall and install fresh on that.
PS. Exported all settings...
Result, it works on the two PC's we use for watching TV :D I've not lost anything by the looks of it either, all channels etc still...
I tried to install MP 1.35 this morning, but I couldn't get any further with the installation on the TV server, see error message...
So not 100% sure if this is a MyTVSeries or FanArt issue, but the episode thumbnails always revert to the series default after restart.
If you go to an episode and open the options and pick choose artwork then choose episode thumbnail it shows the correct thumbnail and says it is remote. Click on it and it goes local instantly and...
So not 100% sure if this is a MyTVSeries or FanArt issue, but the episode thumbnails always revert to the series default after...
So not 100% sure if this is a MyTVSeries or FanArt issue, but the episode thumbnails always revert to the series default after...
When my AVR bit the dust recently I took the opportunity to upgrade my projector to an LS11000 to gain 4K. Install went fine until I switched to my HTPC which is my primary source. When I switch to the HTPC the screen goes blank for a long time and then I have sound, no picture, and in the lower left hand corner:
"Source: HDMI 1
Not...
When my AVR bit the dust recently I took the opportunity to upgrade my projector to an LS11000 to gain 4K. Install went fine until...
When my AVR bit the dust recently I took the opportunity to upgrade my projector to an LS11000 to gain 4K. Install went fine until...
Ok, so perhaps a solution, but not the "right" solution. On the client, within media portal configuration, under TV settings, advanced options, I switched to UNC paths instead of the default RSS, and it's working very well. Sure I had to figure out the paths, but no big deal.
Maybe helpful for someone in the future. Thanks for the...
Ok, so perhaps a solution, but not the "right" solution. On the client, within media portal configuration, under TV settings...
Hi folks. I have an issue with a new install/integration into my mediaportal system. I have a “mediaportal server” which has the TV...
Ran into this problem following an otherwise sucessful upgrade from MP 1.34 x64 to MP 1.35 x64 the CEC Remote plugin which I use just to control volume and standby, will no longer put my devices (TV & AVR) to sleep when the HTPC is put in standby. Also when I wake up the HTPC MP closes or crashes (not sure which) as per the example in...
Ran into this problem following an otherwise sucessful upgrade from MP 1.34 x64 to MP 1.35 x64 the CEC Remote plugin which I use...
Ran into this problem following an otherwise sucessful upgrade from MP 1.34 x64 to MP 1.35 x64 the CEC Remote plugin which I use...