That was unchecked (assuming that not checking it would turn fading off). On the off chance that the code has the setting reversed, I checked it, and now the fading doesn't happen.
I think I remember on previous versions of MP that in addition to turning fading off it is also necessary to set the fade time to 0 seconds. Not sure if current version is the same but it might be worth a try.
I needed to disable fading to prevent damage to dts files when using bitperfect spdif output.
Default Direct Sound Device was the problem.
MPAR worked better than Dircect Sound, but is still a problem.
Changed Audio Renderer to use the TV and it's working.
Default Direct Sound Device was the problem.
MPAR worked better than Dircect Sound, but is still a problem.
Changed Audio Renderer...
New computer build with Windows 11 Pro.
MediaPortal 1.34 x64.
When I pause a video the audio drops out. This only occurs when...
When my AVR bit the dust recently I took the opportunity to upgrade my projector to an LS11000 to gain 4K. Install went fine until I switched to my HTPC which is my primary source. When I switch to the HTPC the screen goes blank for a long time and then I have sound, no picture, and in the lower left hand corner:
"Source: HDMI 1
Not...
When my AVR bit the dust recently I took the opportunity to upgrade my projector to an LS11000 to gain 4K. Install went fine until...
When my AVR bit the dust recently I took the opportunity to upgrade my projector to an LS11000 to gain 4K. Install went fine until...