Autoswitch Ati profile when launching? (1 Viewer)
- Thread starter ZORGLUB
- Start date
France
Users who are viewing this thread
Similar threads
Thanks for letting me know.
Will have a look into that after the holidays. Maybe I am setting the Music folder as default on a new install to prevent the crash.
Thanks for letting me know.
Will have a look into that after the holidays. Maybe I am setting the Music folder as default on a new...
I installed the current version of MPTagThat2 (1.0.0.466) and it closes immediately after launching. The log file is not helpful. I...
There has been some jigger-pokery going on with the Windows volume OSD in newer MP-1 versions to get it and the MP volume OSD to display as per the options in MP Config. The behaviour you are seeing will be fixed in the next release, the Windows volume OSD will appear very briefly on MP exit on the desktop but fades away completely...
There has been some jigger-pokery going on with the Windows volume OSD in newer MP-1 versions to get it and the MP volume OSD to...
Hi,
after a fresh install of MP on a Mini PC, when I exit MP to go back to the desktop, a rectangle appears above the Windows...
You can always use GitHub online
But judging by the picture, you are doing well. Direct Push to Master is prohibited, create PR.
You can always use GitHub online
But judging by the picture, you are doing well. Direct Push to Master is prohibited, create PR.
Hello,
Because I was annoyed with closing MP, launch config, modify setting and start MP again, I decided to give MP the ability...
When my AVR bit the dust recently I took the opportunity to upgrade my projector to an LS11000 to gain 4K. Install went fine until I switched to my HTPC which is my primary source. When I switch to the HTPC the screen goes blank for a long time and then I have sound, no picture, and in the lower left hand corner:
"Source: HDMI 1
Not...
When my AVR bit the dust recently I took the opportunity to upgrade my projector to an LS11000 to gain 4K. Install went fine until...
When my AVR bit the dust recently I took the opportunity to upgrade my projector to an LS11000 to gain 4K. Install went fine until...
Are you trying to use a remote control or a keyboard?
You can customise your input devices using the "Remotes and Other Input Devices" section in "MP Config". Using the "HID" tab, you can:
Customise your remote control, and/or
Customise your keyboard.
Select one or both devices, and then pick the config that you are going to use...
Are you trying to use a remote control or a keyboard?
You can customise your input devices using the "Remotes and Other Input...
Is there some way to change the raw mapping of the windows media center remote? With Hid Demo I find that the 'stop' button...
