Manual setup (1 Viewer)
- Thread starter Glith
- Start date
Sweden
Users who are viewing this thread
Similar threads
Thank you for pointing out that my analysis may be less than accurate. :eek: :p
Although the change to TV channel 71 may not also have been applied to the independent radio channels (different MUXes), the logs that I prepared for one of the development team does show a difference between channel 704 ("BBC Radio 4") and channel 731...
Thank you for pointing out that my analysis may be less than accurate. :eek: :p
Although the change to TV channel 71 may not also...
I have just discovered that I can no longer receive any of the independent radio channels broadcast on DVB-T in the UK. In...
I compliment you on the thoroughness of your investigations. (y)
Unfortunately, I don't have any ideas what the problem might be. :(
Perhaps someone else will post with some suggestions. :unsure:
-- from CyberSimian in the UK
I compliment you on the thoroughness of your investigations. (y)
Unfortunately, I don't have any ideas what the problem might be...
Would appreciate it if someone could solve (or point me in the right direction to resolve) this issue.
I have “MultiSeat”...
@CyberSimian
this workaround worked.
@TLD
this hint was good because I wanted to install x64. Now I have x86 installed
@CyberSimian
this workaround worked.
@TLD
this hint was good because I wanted to install x64. Now I have x86 installed
After reinstalling a WinTV quad HD card and MP1.36, the TV service no longer starts automatically. A manual start is no problem...
I installed the new EXE on my MP 1.36 64-bit system (Win 10 laptop), and... it works fine. (y) :)
Thank you for making this change :). I hope that it will be included in the next release.
-- from CyberSimian in the UK
I installed the new EXE on my MP 1.36 64-bit system (Win 10 laptop), and... it works fine. (y) :)
Thank you for making this...
In "MP Config" the following setting enables the display of channel numbers in the TV EPG:
But there is no equivalent setting in...
Thank you both for your good and very detailed advice.
I think I will try to go for the x86 install.
Thank you both for your good and very detailed advice.
I think I will try to go for the x86 install.
Hello great people !
I have an old Win7 setup running the 1.29 build and I'm making a new htpc on Win11.
I have made a backup and...