Sourceforge Down (1 Viewer)
- Thread starter Efros
- Start date
England
Users who are viewing this thread
Similar threads
If you use "Manual Booking" (left side menu on the "Recording Schedule" panel), you can schedule a recording duration of up to 24 hours. However...
That is using the "conventional" TV sources, i.e. a DVB-T tuner, a DVB-S tuner, or an analogue tuner. You stated in your other thread that you are using an IPTV source. Perhaps there is a...
If you use "Manual Booking" (left side menu on the "Recording Schedule" panel), you can schedule a recording duration of up to 24...
Is there a limit to recording length? My TVServer recordings all cut off at 3 hours but I can't find a setting anywhere to change...
4.5 is really old. I'm not sure 4.5.5 even is a version that actually existed. You should be able to install .NET Framework 4.8.0 on Windows 7 SP1
4.5 is really old. I'm not sure 4.5.5 even is a version that actually existed. You should be able to install .NET Framework 4.8.0...
My TV PC is more a cast-off on older hardware (a 'Quiet PC' i5 4690, 16GB ram, 2xSSD 1xHDD, system graphics), mainly as a cheap way...
I used to use the grabber but a few years back it disappeared on FreeSat DVBS. That is when I changed to EPG Collector. The extra benefit is that it collects from the Sky platform so it will give EPG for all the FreeSat channels plus the unencrypted movie channels on the Sky platform. It also allows me to pick the channels dedicated...
I used to use the grabber but a few years back it disappeared on FreeSat DVBS. That is when I changed to EPG Collector. The extra...
Hi everyone, I hope you are all well
My Mum's Mediaportal lost it's marbles thanks to Microsoft update, (even though I had update...
When i was using 2.5, and like im using MP1, i set the resolution of my desktop. And MEPo just uses whatever i have set.
When i was using 2.5, and like im using MP1, i set the resolution of my desktop. And MEPo just uses whatever i have set.
MP 2.5 does not recognize my Bravia 32S5100 as 1920x1080 but only as 1280x720. The PC's monitor is recognized as 1920x1080. Both...
100% my bad - as expected :)
So, I had disabled the Windows Update service. Not a wise move, until MP all installed and working nicely. The reason it failed is because DotNetFrameworkChecker.cs looks in Registry HKLM SOFTWARE\\Microsoft\\NET Framework Setup\\NDP for v4/v4.0 AND v3.5. W10 has V4.0 but not 3.5. MP installer...
100% my bad - as expected :)
So, I had disabled the Windows Update service. Not a wise move, until MP all installed and working...
Just tried a new Client-only install on a clean Win10 Pro box. Installer doesnt realise .NET 4 Framework already 'installed' (part...