Try mapping a button of the remote to x ? Or just map the remote to the right command through MP config.
I don't use MCE IR Trans, so can't help. I use eventghost to do this exact same thing.
According to Wikipedia, Windows only uses code pages other than UTF-8 to support legacy (mostly 32 bit) applications and supports two code pages in addition to UTF-8 (OEM and ANSI). According to Microsoft, UTF-8 has been the preferred character set since 2019. If TV Server (or its import routine) were using UTF-8, then umlauts...
According to Wikipedia, Windows only uses code pages other than UTF-8 to support legacy (mostly 32 bit) applications and supports...
Because I have around 200 TV channels and more than a dozen groups, I tried to import the TV channel groups from an old export.xml...
Thumbnail issue resolved:
I understand that the problems related to the creation of thumbnails are quite common and also happened to me.
Here the solution to my problem: MP2/Settings/Media Library/Film Import Settings/FanArt offline caching
here it is important to select the location where TV recordings are stored. In my case, the...
Thumbnail issue resolved:
I understand that the problems related to the creation of thumbnails are quite common and also happened...
There seems to be an issue how MP2 is displaying TV recordings depending on whether the media source is on a local hard drive or a...
Ran into this problem following an otherwise sucessful upgrade from MP 1.34 x64 to MP 1.35 x64 the CEC Remote plugin which I use just to control volume and standby, will no longer put my devices (TV & AVR) to sleep when the HTPC is put in standby. Also when I wake up the HTPC MP closes or crashes (not sure which) as per the example in...
Ran into this problem following an otherwise sucessful upgrade from MP 1.34 x64 to MP 1.35 x64 the CEC Remote plugin which I use...
Ran into this problem following an otherwise sucessful upgrade from MP 1.34 x64 to MP 1.35 x64 the CEC Remote plugin which I use...
Ok, so perhaps a solution, but not the "right" solution. On the client, within media portal configuration, under TV settings, advanced options, I switched to UNC paths instead of the default RSS, and it's working very well. Sure I had to figure out the paths, but no big deal.
Maybe helpful for someone in the future. Thanks for the...
Ok, so perhaps a solution, but not the "right" solution. On the client, within media portal configuration, under TV settings...
Hi folks. I have an issue with a new install/integration into my mediaportal system. I have a “mediaportal server” which has the TV...