BlackGold BGT3630 - When will disecq be supported..? (1 Viewer)
- Thread starter retro
- Start date
)- September 1, 2008
- 21,577
- 8,224
- Home Country
-
New Zealand
DiSEqC 1.0 4 port switching will be supported with the next generation TV Server. It should already work with MediaPortal 2 and the corresponding version of TV Server:
https://forum.team-mediaportal.com/threads/testbuilds-for-native-mp2-tv.114068/
[edit: I note that as far as I know the drivers are not capable of sending raw DiSEqC commands, so motor/positioner and 16 port DiSEqC support are not planned.]
https://forum.team-mediaportal.com/threads/testbuilds-for-native-mp2-tv.114068/
[edit: I note that as far as I know the drivers are not capable of sending raw DiSEqC commands, so motor/positioner and 16 port DiSEqC support are not planned.]
Last edited:
Users who are viewing this thread
Similar threads
Having exactly this issue upon performing a clean install of MediaPortal 1.34 64 bit on a clean Windows 11 install, off to try 1.33
Having exactly this issue upon performing a clean install of MediaPortal 1.34 64 bit on a clean Windows 11 install, off to try 1.33
Hi,
went from a 1.29 install (working, reinstalled for other reasons) on a fairly fresh and fully updated Windows 10 system for a...
Many thanks for the answer.
So far I've used Logitech's Harmony hub. This allows you to control all components (including the media portal). I have now contacted the Sofabaton hotline. It should also work here like with the Harmony. Unfortunately, not all of the IR codes are correct. You can also learn commands here. But that doesn't...
Many thanks for the answer.
So far I've used Logitech's Harmony hub. This allows you to control all components (including the...
I don't have a complicated A/V system - a Sony A8H TV, Yamaha receiver, and a HTPC on which I run most media through MediaPortal. I...
@Brownard, just a stupid question.
Yes it works now by manually entering the path. However when i try to edit the settings (like because i want to disable the share watch)
I can select my Media Source, however i seems to only briefly been shown and the goes back to the list. So i cannot actually edit it.
Can et bee due to the "long"...
@Brownard, just a stupid question.
Yes it works now by manually entering the path. However when i try to edit the settings (like...
I had to replace my NAS and after reinstalling a new one i thought.
Lets modify the Media Source.
- However that did not work "if"...
Default Direct Sound Device was the problem.
MPAR worked better than Dircect Sound, but is still a problem.
Changed Audio Renderer to use the TV and it's working.
Default Direct Sound Device was the problem.
MPAR worked better than Dircect Sound, but is still a problem.
Changed Audio Renderer...
New computer build with Windows 11 Pro.
MediaPortal 1.34 x64.
When I pause a video the audio drops out. This only occurs when...
You can always use GitHub online
But judging by the picture, you are doing well. Direct Push to Master is prohibited, create PR.
You can always use GitHub online
But judging by the picture, you are doing well. Direct Push to Master is prohibited, create PR.
Hello,
Because I was annoyed with closing MP, launch config, modify setting and start MP again, I decided to give MP the ability...
