I have an AVERmedia a169 dual tuner tv card and for some reason MediaPortal says that I have no TV capture card. I am running XP Home edition. Anyone have any ideas?
Following on our discussion in IRC last night, windows XP home should be fine for mediaportal.
It's just a matter of installing the correct driver and then telling MP how to work with it in the definitions file. Logfiles would help. Pretty sure this is a case where BDA drivers do not exist for the card so there are a few more things needed than that for BDA drivers.
The drivers I have are only 2.3.30.19 so it looks like you found newer ones. I'll give them a shot. I'm pretty sure that the ones that are 1.3 k are corrupt or not complete. But the other one might work. I'll let you know. Thanks again.
Ok so it looks like both sets of drivers are bad. the one that is 1.3 MB says unexpected end of archive and the 1.3k says it's corrupt or incomplete. I have a feeling that the fact that it may be an OEM card could be a problem. I sent avermedia a ticket about it (I found an english site for it) so lets see what they say if anything. Let me know what logs you want to look at and I will upload them. Thanks again....lets see if we can nip this in the @!#
I have not experienced that myself, and I don't know of any reason why that might occur (but my knowledge of how TV Server works is not extensive).
It is strange that you mention this because there are now four DVB-T channels in the UK that behave in the same way (this is new for the UK). I think that these might be some sort of...
I have not experienced that myself, and I don't know of any reason why that might occur (but my knowledge of how TV Server works is...
I am running MePo 1.32 X86 on
Windows 11
Ryzen 9 7900X
32GB DDR5 RAM
1TB NVME Boot Drive
4TB NVME Data drive
RTX 3060 12GB
I have...
I've setup my HDHomeRun in MP1 as (4) IPTV cards rather than Atsc. I can see the (4) Atsc cards, but just have them disabled. I did it this way so I didn't have to edit the channel names every time tested a new TV-server install. Anyway, it works. I don't know if this would get you past the BDA driver issue. I'll provide more...
I've setup my HDHomeRun in MP1 as (4) IPTV cards rather than Atsc. I can see the (4) Atsc cards, but just have them disabled. I...
I am brand new to MediaPortal.
I have installed MP 2.4.1 on Windows 10. It is a fresh install and fully up to date.
I have an...
When my AVR bit the dust recently I took the opportunity to upgrade my projector to an LS11000 to gain 4K. Install went fine until I switched to my HTPC which is my primary source. When I switch to the HTPC the screen goes blank for a long time and then I have sound, no picture, and in the lower left hand corner:
"Source: HDMI 1
Not...
When my AVR bit the dust recently I took the opportunity to upgrade my projector to an LS11000 to gain 4K. Install went fine until...
When my AVR bit the dust recently I took the opportunity to upgrade my projector to an LS11000 to gain 4K. Install went fine until...